Air Heater

Suitable for all modifications of air heaters AUTOTERM Air 4D (previously known as PLANAR 44D). Voltage: 12V Air pump for AUTOTERM 4D-12, assy.1911-01 

Suitable for all modifications of air heaters AUTOTERM Air 4D (previously known as PLANAR 44D ).  Voltage: 24V Air pump for PLANAR 44D-24, assy.1881-01 

Silent Fuel pump is suitable for the following AUTOTERM heaters with voltage 12V: Air heaters: AUTOTERM Air 4D AUTOTERM Air 8D  AUTOTERM Air 9D  Engine pre-heaters: AUTOTERM Flow 14D  Specifications: Voltage: 12V 100 tick dose: 6.8 ml TH-11 Silent...

The glow plug is suitable for air heaters with serial numbers that start with the following numbers: AUTOTERM Air 4D (previously known as PLANAR 44D)  Voltage - 12V:  4142xxxxxxx (Control unit assy.4144) 4191xxxxxxx (Control unit assy.4002) Voltage -...

Gasket repair kit For AUTOTERM Air 4D   Gasket repair kit for AUTOTERM Air 4D (previously known as PLANAR 44D), assy.2164  The gasket repair kit is suitable for all modifications of air heaters AUTOTERM Air 4D (previously known as PLANAR 44D)...

The gasket for AUTOTERM Air 4D (previously PLANAR 44D), assy.P3495  The gasket is suitable for the following air heaters: PLANAR-44D-12-GP-??-P-3045  PLANAR-44D-24-GP-??-P-3030 AUTOTERM Air 4D This gasket is placed between the air pump and an air...

Temperature and overheat sensor For PLANAR 44D   Temperature and overheat sensor, assy.3058  The temperature and overheat sensor is suitable for air heater model: PLANAR 44D-12-GP-P-3045 PLANAR 44D-24-GP-P-3030 PLANAR 4DM2-12-GP-P-3585 PLANAR...

Little Snugger Diesel Heater Inlet ManifoldLittle Snugger Diesel Heater Inlet ManifoldInlet Manifold for Little Snugger Diesel Heater.Inlet Manifold for Little Snugger Diesel Heater.

Little Snugger Diesel Heater Control UnitControl Unit for Little Snugger Diesel Heater

Little Snugger Diesel Heater Glow Pin - Yellow/Green2015+Glow Pin for Little Snugger Diesel Heater - Yellow/Green2015+

Little Snugger Diesel Heater Fuel PumpFuel Pump for Little Snugger Diesel Heater

Spark Ignition Electrode for Truma S3002 - 1996-2004 Suitable for Trumatic S3002 heaters made after 1993 - for appliances with front case in new design.  Used also on S3002P heaters. 75cm long

This unit allows you to upgrade your existing Truma S3002/S3004, S5002/S5004 fire so it can be mains electric powered with a thermostat control (Control panel & 3m connection cable included).  The ultraheat has 3 power settings: 500w – 2.2A / 1000w...

Truma Ultraheat 230V Control Panel & Frame. Settings are 2000, 1000, 500 & off The dial runs from 1–9 Please note that the old type (part number: 30030-98500 / 30030-98400) is no longer available and has been replaced by this.

Temperature Control Device for Truma Heater S Model Suitable for all Truma S Model Heaters